FAQ
The polymer base is polyactic acid and polyhydroxy butyrate blend (PLA/PHB)
Yes, printing with NonOilen is as easy as PLA. More detailed information can be found here.
The buildplate must be very well cleaned with IPA. Please use PVA gluestick (Kores/UHU) or 3dLac. Recommended temperature are 195/190 °C and 50 °C on hotbed. Same speed as PLA. Fan speed 50-100% depending on the power of your fan. There is no need to use raft. We use only skirt, but brim should be no problem. We have printed several parts which are 25 cm in diameter without any issue. If you have further questions do not hesitate to contact us directly at helpdesk@fillamentum.com
The basic comparison of all our products can be found here.
Yes, it is. For more information, see the Drying filaments before proccessing table.
Yes, you can buy a 15 m (1.75 mm) or 6 m (2.85 mm) sample on our eshop.
The painting wasn’t tried as it is a brand-new material and the post-processing methods are not usually tested. Yes, the planter is an ideal application.
This means that it is biodegraded from 100 % in compost without remaining any microparticles smaller than 2 mm which would be harmful to the environment. This material is stable and doesn’t degrade during processing or usage. For more information, have a look at our learning videos, we explain the differences from so-far-known bioplastics.
Yes, you can. But to be sure that the material will resist chemicals for a longer time, use more perimeters and top/bottom layers.
